Bearing assembly in rear hubs
4 posts
• Page 1 of 1
Does the inner bearing [type 18 with wide bearing] go with the protuding inner part facing into the housing? cheers, John.
- AussieJohn
- Third Gear
- Posts: 456
- Joined: 10 Jun 2007
John
Yes,and don't forget to trim the protruding rubber seal,it stops the cover-plate fitting in the housing,mine was rusted through so replaced with a plastic one (Blue Peter washing-up bottle)
John
Yes,and don't forget to trim the protruding rubber seal,it stops the cover-plate fitting in the housing,mine was rusted through so replaced with a plastic one (Blue Peter washing-up bottle)
John
-
john.p.clegg - Coveted Fifth Gear
- Posts: 5745
- Joined: 21 Sep 2003
Hi John, is the coverplate a circular tinplate dirtshield? I have heard about these but have yet to see one. Is this what you replaced? cheers, John.
- AussieJohn
- Third Gear
- Posts: 456
- Joined: 10 Jun 2007
4 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 35 guests