elan tire size
6 posts
• Page 1 of 1
I have an Elan KO wheel 4 1/2J by 13. What modern size tire would be closest to original. I believe the original was a 165 R13.
I am using this as a spare tire for my Elan +2 with 14 inch wheels. I would assume the largest outside diameter tire would be best.
Bob
I am using this as a spare tire for my Elan +2 with 14 inch wheels. I would assume the largest outside diameter tire would be best.
Bob
- rdssdi
- Fourth Gear
- Posts: 965
- Joined: 30 Sep 2003
Bob
In the sixties the aspect ratio was uniform at about 78% until Firestone introduced the 70 series Wide Oval and then the 60 series, so the modern equivalent simply adds the aspect ratio closest to that of the sixties which is /80.
Hence a 165/80 X 13 is what will be equivalent to the original tire. HTH Ross
In the sixties the aspect ratio was uniform at about 78% until Firestone introduced the 70 series Wide Oval and then the 60 series, so the modern equivalent simply adds the aspect ratio closest to that of the sixties which is /80.
Hence a 165/80 X 13 is what will be equivalent to the original tire. HTH Ross
- Ross Robbins
- Third Gear
- Posts: 298
- Joined: 03 Apr 2006
The S3 Elan had a 145/82 R13 (radial ply) tyre on a 4.1/2 J rim; this tyre/wheel combination had a 1725mm (+1.5/-2.5%) rolling circumference
Note: early Elans had a 5.20 x 13 cross ply tyre.
The S4 had a 155/82 R13 tyre on a 4.1/2 J rim: 1765mm (+1.5/-2.5%) rolling circumference
The +2 had a 165/82 R13 tyre on a 5.1/2 J rim: 1820mm (+1.5/-2.5%) rolling circumference
Your 14-inch 6J rims were intended to have a 185/60 R14 tyre, and these have a 1765mm (+1.5/-2.5%) rolling circumference
So, if you do have these fitted, then you would need either:
a) 155/82 R13: 1765mm (+1.5/-2.5%) rolling circumference, or
b) 175/70 R13: 1770mm (+1.5/-2.5%) rolling circumference, or
c) 205/60 R13: 1755mm (+1.5/-2.5%) rolling circumference (but don't go there, obviously, as it will foul?)
Note: early Elans had a 5.20 x 13 cross ply tyre.
The S4 had a 155/82 R13 tyre on a 4.1/2 J rim: 1765mm (+1.5/-2.5%) rolling circumference
The +2 had a 165/82 R13 tyre on a 5.1/2 J rim: 1820mm (+1.5/-2.5%) rolling circumference
Your 14-inch 6J rims were intended to have a 185/60 R14 tyre, and these have a 1765mm (+1.5/-2.5%) rolling circumference
So, if you do have these fitted, then you would need either:
a) 155/82 R13: 1765mm (+1.5/-2.5%) rolling circumference, or
b) 175/70 R13: 1770mm (+1.5/-2.5%) rolling circumference, or
c) 205/60 R13: 1755mm (+1.5/-2.5%) rolling circumference (but don't go there, obviously, as it will foul?)
- 45bvtc
- Second Gear
- Posts: 76
- Joined: 27 Mar 2009
Bob,
If you are using 14" wheels, probably you are using 185/60-14 tyres. These have a nominal rev/mile figure of 915.
Close sizes to this are 155-13 at 912 rev/mile and 175/70-13 at 917 rev/mile.
elan-f15/speed-candidate-conversion-chart-t16331-14.html has a down loadable spreadsheet where one of the sheets has many tyres sorted by rev/mile so that you can see what your options are.
elan-f15/updated-spreadsheets-t18445.html has another down loadable spreadsheet with the same information presented in different formats.
David
1968 36/7988
If you are using 14" wheels, probably you are using 185/60-14 tyres. These have a nominal rev/mile figure of 915.
Close sizes to this are 155-13 at 912 rev/mile and 175/70-13 at 917 rev/mile.
elan-f15/speed-candidate-conversion-chart-t16331-14.html has a down loadable spreadsheet where one of the sheets has many tyres sorted by rev/mile so that you can see what your options are.
elan-f15/updated-spreadsheets-t18445.html has another down loadable spreadsheet with the same information presented in different formats.
David
1968 36/7988
-
msd1107 - Fourth Gear
- Posts: 765
- Joined: 24 Sep 2003
6 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 13 guests