alloy wheel PCD of wheel drive pegs
2 posts
• Page 1 of 1
Post by: bob_rich » Sun Sep 19, 2010 4:46 pm
Hi Folks
I want to make up a wrench to take the torque reaction when carrying out various tasks on the rear suspension. Anyone know the official Pitch Circle Diameter (PCD ) of the 5 drive pegs in the drive flange used with the alloy wheels. I can measure it but to be sure would like to know the design value so I can make up a plate that is a good fit
cheers
Bob
I want to make up a wrench to take the torque reaction when carrying out various tasks on the rear suspension. Anyone know the official Pitch Circle Diameter (PCD ) of the 5 drive pegs in the drive flange used with the alloy wheels. I can measure it but to be sure would like to know the design value so I can make up a plate that is a good fit
cheers
Bob
- bob_rich
- Fourth Gear
- Posts: 555
- Joined: 06 Aug 2009
Post by: elj221c » Mon Sep 20, 2010 1:18 pm
The last post in this thread elan-f15/knock-alloy-wheel-drive-pegs-t21163-30.html has a link to a drawing on the Golden Gate Lotus Club site that you might find useful.
Roy
'65S2
Roy
'65S2
Roy
'65 S2
'65 S2
-
elj221c - Fourth Gear
- Posts: 539
- Joined: 12 Sep 2003
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 14 guests
Site map
SitemapIndex
RSS Feed