Ko Hub Drive Pegs
2 posts
• Page 1 of 1
Post by: type26owner » Sun Sep 21, 2003 1:57 pm
<a href='http://www.tirerack.com/wheels/tech/boltpatt.htm' target='_blank'>http://www.tirerack.com/wheels/tech/boltpatt.htm</a>
Using the standard technique for measuring a 5_lug wheel the drive pegs on the KO hubs it appears to be a 5_x_132mm pattern. Can anyone confirm or correct this value? I'm building a lug-centric adapter hub to use on a tire truer and balancer.
Keith
Using the standard technique for measuring a 5_lug wheel the drive pegs on the KO hubs it appears to be a 5_x_132mm pattern. Can anyone confirm or correct this value? I'm building a lug-centric adapter hub to use on a tire truer and balancer.
Keith
- type26owner
- Coveted Fifth Gear
- Posts: 1246
- Joined: 18 Sep 2003
Post by: type26owner » Mon Sep 22, 2003 12:55 am
This measurement is correct. The adapter fit perfectly with .425 diameter drive pegs which rattled a tiny bit in a brand new wheel which meant the spacing between the pegs was nearly perfect. Does anyone want a drawing of the adapter?
Keith
Keith
- type26owner
- Coveted Fifth Gear
- Posts: 1246
- Joined: 18 Sep 2003
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 23 guests
Site map
SitemapIndex
RSS Feed