Two Gates Minilite Pattern Wheels
1 post
• Page 1 of 1
Hello All,
Have any of you experienced problems with these wheels.
I have used them and found that the pegs have distorted the wheels as a result of the pegs not having sufficient clearance. The depth of the holes is between 1/8 and 3/16 less than on my standard +2 alloys!
Regards,
Colin
Have any of you experienced problems with these wheels.
I have used them and found that the pegs have distorted the wheels as a result of the pegs not having sufficient clearance. The depth of the holes is between 1/8 and 3/16 less than on my standard +2 alloys!
Regards,
Colin
- blueplastic72
- New-tral
- Posts: 9
- Joined: 14 Sep 2003
1 post
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 32 guests