Differential Clean Out
1 post
• Page 1 of 1
I started a previous thread in relation to my output shaft fracturing and, in the process, terminating my alloy diff housing
I have the diff out now and there are metal fragments all through it. I can rinse petrol through it, etc, but I'm not sure whether this will be effective enough in ensuring clean faces on the bearings, etc.
The diff was fine apart from a small whine at 50 mph - maybe I should get it cleaned and rebuilt.
If anyone has suggestions on cleaning it out then that would be great - in any case, all advice appreciated.
Cheers
I have the diff out now and there are metal fragments all through it. I can rinse petrol through it, etc, but I'm not sure whether this will be effective enough in ensuring clean faces on the bearings, etc.
The diff was fine apart from a small whine at 50 mph - maybe I should get it cleaned and rebuilt.
If anyone has suggestions on cleaning it out then that would be great - in any case, all advice appreciated.
Cheers
Stuart - Sydney
1968 +2 50/1035
1968 +2 50/1035
- Stuart+2
- Second Gear
- Posts: 118
- Joined: 18 Nov 2006
1 post
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 19 guests