Is This Noise The Clutch Release Bearing?
18 posts
• Page 2 of 2 • 1, 2
Post by: adigra » Tue May 15, 2018 11:02 am
Makes sense. Thank you for the update. Quite irritating for me as it's engine out yet again (Spyder did my clutch and all new parts only a couple of thousand miles ago).
Thanks again.
Best,
Adi
Thanks again.
Best,
Adi
1967 Elan S3 S/E FHC
-
adigra - Third Gear
- Posts: 442
- Joined: 01 May 2009
Post by: Stevie-Heathie » Tue May 15, 2018 1:44 pm
Yes - irritating to the tune of ?1000 of labour!
There are some duff bearings on the market I was told - perhaps you were unlucky? Worth asking for a goodwill gesture from Spyder?
There are some duff bearings on the market I was told - perhaps you were unlucky? Worth asking for a goodwill gesture from Spyder?
1967 S3 SE DHC
1970 +2S (RIP - went out in a blaze of glory in 2001)
1970 +2S (RIP - went out in a blaze of glory in 2001)
-
Stevie-Heathie - Third Gear
- Posts: 276
- Joined: 08 Dec 2015
Post by: adigra » Tue May 15, 2018 2:19 pm
It's fine, I have a few other jobs on the list which will be done at the same time for which I need the gearbox out anyhow. In for a penny...
Sadly I didn't have the best experience with Spyder the last couple of times, so I feel there isn't much goodwill going around.
Sadly I didn't have the best experience with Spyder the last couple of times, so I feel there isn't much goodwill going around.
1967 Elan S3 S/E FHC
-
adigra - Third Gear
- Posts: 442
- Joined: 01 May 2009
18 posts
• Page 2 of 2 • 1, 2
Total Online:
Users browsing this forum: No registered users and 24 guests
Site map
SitemapIndex
RSS Feed