Alternative siource for 5 speed clutch?

PostPost by: vincereynard » Tue Apr 11, 2017 2:17 pm

Whist I'm at it I've decided I may as well replace the entire clutch assembly. It may be lighter? Although having the correct slave will be a plus!

I imagine it is a standard 8.5 inch Borg and Beck device. I cannot see why it would be any different just 'cos it 's in a Lotus.

Any idea what other vehicle had the same fitted?
vincereynard
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 1071
Joined: 12 Jan 2015

PostPost by: john.p.clegg » Tue Apr 11, 2017 6:29 pm

Vince

lotus-gearbox-f37/speed-clutch-t29900.html?hilit=clutch

John :wink:

P.S. But I believe it is 1 1/16" 25 splines
User avatar
john.p.clegg
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 4521
Joined: 21 Sep 2003

PostPost by: Grizzly » Sat Apr 15, 2017 9:34 am

I think i have a 5 speed Friction plate i bought years ago by mistake, if it's any good to you i'll dig it out and send it you?
Chris
User avatar
Grizzly
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 1857
Joined: 13 Jun 2010

PostPost by: vincereynard » Sat Apr 15, 2017 12:41 pm

Grizzly wrote:I think i have a 5 speed Friction plate i bought years ago by mistake, if it's any good to you i'll dig it out and send it you?


Cheers Chris I'll PM you.
vincereynard
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 1071
Joined: 12 Jan 2015

PostPost by: mbell » Sat Apr 15, 2017 2:04 pm

One useful snippet I found on the forums when I was considering if I should fit a new plate on my car while the engine was out was that new plates for 5 speeds need some machining to reduce the thickness of the rear spine section to fit.

I decided not to replace mine as it was in New condition and proven to work well. So the hassle/risk to get a new one machined didn't seem worth it.

I'd recommend that you check the fit of any plate you get to see if the machining is required before putting everything together.
'73 +2 130/5 RHD, now on the road and very slowly rolling though a "restoration"
mbell
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 2640
Joined: 07 Jun 2013

PostPost by: john.p.clegg » Sat Apr 15, 2017 2:25 pm

Covered here...

lotus-gearbox-f37/speed-clutch-t29900.html?hilit=clutch

A light skim with an angle grinder does the job,I did mine while it was being rotated on a short round bar fixed in the vice..

John :wink:
User avatar
john.p.clegg
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 4521
Joined: 21 Sep 2003

Total Online:

Users browsing this forum: No registered users and 17 guests

cron