Surprise clutch thing
2 posts
• Page 1 of 1
Had the engine out this week for a possible issue unrelated to the clutch: noticed the D ring that activates the clutch was significantly worn from rubbing against the release bearing! Oddly it wasn't noisy enough to think there was a problem, or at least in my hearing frequency, and the clutch worked fine. It was only partially out of position on one side, little springs still in place. I suspect the clutch lever was bumped when putting combined eng/trans into the car partially dislodging the D ring off the groove.
There you go, something new to fret about
Jack
There you go, something new to fret about
Jack
- jk952
- Third Gear
- Posts: 258
- Joined: 04 Jan 2011
My clutch fork waited until everything was in place before it gleefully tinkled its self apart. many strong epithets and Anglo Saxon mutterings ! Ed
dont close your eyes --you will miss the crash
Editor: On June 12, 2020, Edward Law, AKA TwinCamMan, passed away; his obituary can be read at https://www.friscolanti.com/obituary/edward-law. He will be missed.
Editor: On June 12, 2020, Edward Law, AKA TwinCamMan, passed away; his obituary can be read at https://www.friscolanti.com/obituary/edward-law. He will be missed.
-
twincamman - Coveted Fifth Gear
- Posts: 2453
- Joined: 02 Oct 2003
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 26 guests