MT 75 clutch activation
2 posts
• Page 1 of 1
Hi - have managed to shoehorn an ex Scorpio MT 75 into a standard 1967 S3 chassis.
Does anybody know what is a suitable bore for the concentric clutch master cylinder ? will the standard .625" do the job or do I need to go up a size or two ?
Also does anyone supply a feed/bleed hose kit that will suit the concentric slave / Girling style master cylinder.
Does anybody know what is a suitable bore for the concentric clutch master cylinder ? will the standard .625" do the job or do I need to go up a size or two ?
Also does anyone supply a feed/bleed hose kit that will suit the concentric slave / Girling style master cylinder.
- seascape
- New-tral
- Posts: 1
- Joined: 14 May 2014
Seascape,
I think I remember being told by Spyder Engineering that a 5/8 master cylinder is what they use with an MT75. I expect Spyder would be willing to confirm or correct my memory.
Richard Hawkins
I think I remember being told by Spyder Engineering that a 5/8 master cylinder is what they use with an MT75. I expect Spyder would be willing to confirm or correct my memory.
Richard Hawkins
- RichardHawkins
- Coveted Fifth Gear
- Posts: 1280
- Joined: 05 Jul 2008
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 37 guests