clutch slave/heat shield
5 posts
• Page 1 of 1
Bob,
I attached a piece of 1/2" X1/2" angle aluminum to the two dust cover bolts on the bottom of the bell housing running it to the left. I think I had to bend it up slightly. It went above the headers. Then I bolted a piece of aluminum sheet to the end of the angle aluminum which "spoons" the slave, isolating it from the headers. I remember I had to pull the sheet around the slave and bend it to form a shield as I went. Hope this helps.
I attached a piece of 1/2" X1/2" angle aluminum to the two dust cover bolts on the bottom of the bell housing running it to the left. I think I had to bend it up slightly. It went above the headers. Then I bolted a piece of aluminum sheet to the end of the angle aluminum which "spoons" the slave, isolating it from the headers. I remember I had to pull the sheet around the slave and bend it to form a shield as I went. Hope this helps.
Frank Howard
'71 S4 SE
Minnesota
'71 S4 SE
Minnesota
- Frank Howard
- Fourth Gear
- Posts: 919
- Joined: 30 Mar 2004
5 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 17 guests