Zen secrets of the elan parking brake system
2 posts
• Page 1 of 1
WELLL ---the reason I only had 2 clicks on the umbrella handle was --the clevis at the rear would contact the diff mount casting jamming it ---That was caused by the extender pipe I ha d place in the rear of the handle to take up excess slack and moving the actuator leaver too far forward --WRONG THINKING ---1st with a slack cable tighten the rear adjusting nut until the wheel cant move and back off one notch[ both sides please ]--------then its all good lots of travel for the handle to do its job ---------while doing the job I discovered the rear outer A arm was loose that could have let to an embarrassing moment ----- ed
dont close your eyes --you will miss the crash
Editor: On June 12, 2020, Edward Law, AKA TwinCamMan, passed away; his obituary can be read at https://www.friscolanti.com/obituary/edward-law. He will be missed.
Editor: On June 12, 2020, Edward Law, AKA TwinCamMan, passed away; his obituary can be read at https://www.friscolanti.com/obituary/edward-law. He will be missed.
-
twincamman - Coveted Fifth Gear
- Posts: 2460
- Joined: 02 Oct 2003
Time for a general spanner check Ed, methinks !
In fact, come to think of it, I'd better do the same.
Regards,
Stuart.
In fact, come to think of it, I'd better do the same.
Regards,
Stuart.
- stuartgb100
- Fourth Gear
- Posts: 813
- Joined: 10 Sep 2005
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 23 guests