Lockheed Brake Servo
6 posts
• Page 1 of 1
Post by: terryp » Fri Dec 21, 2007 3:07 pm
Hello
Me again, I bought my servo and it arrived today. Can anyone email me a scan of some fitting instructions as mine has arrived via eBay without instructions. I'm not sure how to mount it and what direction to face the air valve
Many Thanks and Happy Christmas to everyone. I hope my stocking on Christmas mornong is full of +2 Spares!
Terry
email address
Me again, I bought my servo and it arrived today. Can anyone email me a scan of some fitting instructions as mine has arrived via eBay without instructions. I'm not sure how to mount it and what direction to face the air valve
Many Thanks and Happy Christmas to everyone. I hope my stocking on Christmas mornong is full of +2 Spares!
Terry
email address
Last edited by terryp on Sat Nov 27, 2021 1:03 pm, edited 1 time in total.
- terryp
- Coveted Fifth Gear
- Posts: 1264
- Joined: 29 Nov 2007
Post by: Robbie693 » Fri Dec 21, 2007 3:48 pm
This was useful when I fitted mine
- Attachments
-
RemoteServo.pdf- (1.1 MiB) Downloaded 1543 times
-
Robbie693 - Coveted Fifth Gear
- Posts: 1517
- Joined: 08 Oct 2003
Post by: terryp » Fri Dec 21, 2007 4:18 pm
Robbie
I've read the leaflet and looked at a few pictures of +2 engine compartments on the net , all of which have the servo mounted incorrectly (according to the instructions) Where and how did you end up mounting yours? (presumably without adding a bulge to the bonnet!
Best Regards
Terry
I've read the leaflet and looked at a few pictures of +2 engine compartments on the net , all of which have the servo mounted incorrectly (according to the instructions) Where and how did you end up mounting yours? (presumably without adding a bulge to the bonnet!
Best Regards
Terry
- terryp
- Coveted Fifth Gear
- Posts: 1264
- Joined: 29 Nov 2007
6 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 28 guests
Site map
SitemapIndex
RSS Feed