Lotus Elan

Lifting and supporting the Elan plus 2

PostPost by: TonyA » Sat Jun 15, 2024 4:10 pm

Plus2 front jacking aid diagram.jpg and
Plus2 front jack aid photo.jpg and
Plus2 rear jacking aid diagram.jpg and
Plus2 rear jack aid photo.jpg and
Plus2 rear chassis support.jpg and
We all know the Elan's fibreglass body, backbone chassis (with exhaust down
the middle) and fragile jacking points make it awkward to lift and support the car to work on, especially at the rear.

I have spent a lot of time on the forum archives on how/where and with what to lift and support the car. A lot of the debate is predicated on the difficulty of supporting the narrow backbone at the rear, wether where and how to lift and support on the fibreglass, and there are many conflicting views on 2 post lifts, Quickjack, Eazilift , specially made woodembeams and others. At the front, lifting and supporting the car is easier, the difficulties are the low clearance to get a jack under, and the ease of denting the relatively thin steel thickness.

Here are my solutions

At the front, I cut a "plank" of wood, same size as the Crossmember, with two features to help locate the jack, first, an locating block under the plank with a hole the diameter of the jack pad, second a lip at the front if the plank to stop it being pushed backwards as the jack is engaged..The jack I bought is Halfords 2 tonne Low Profile, which has plenty of lift, length and low entry: fantastic value.
Once lifted up to desired height, I use conventional axle stands to support but with the saddles, which seem always to be " u" sharped, modified to be flat: this stops them digging into the wood plank. Diagram with dimensions and photo at start of thus post.

At the back, I made a saddle for the jack from 1/4 inch steel plate, angle iron and oak blocks: set just far enough apart to fit in the chassis, and inside distance apart and hight enough to avoid the exhaust pipe .See diagram, with dimensions and photo

To support the backbone chassis at the back for doing work eg fitting CV joints, I discovered and bought a square based stand with screw saddle, used for holding up static caravans: they come in different sizes, mine has a 12 inch square base and min height 9 inches and a saddle wider than the width of the backbone chassis.
I converted the saddle to take a pair of oak blocks and angle iron . Very strong, very adjustable, very stable. I use the oak block chassis jacking aid to lift the car close to the rear body attachment bolts and once lifted, support the car with the modified caravan stand on the backbone chassis under the diff between the rear wishbone arm chassis mounting points. See photo.

Hope this helps..Cheers..Tony
Last edited by TonyA on Sun Jul 07, 2024 6:35 pm, edited 1 time in total.
TonyA
Second Gear
Second Gear
 
Posts: 163
Joined: 04 Jan 2022
Location: London

PostPost by: Johnny America » Tue Jun 18, 2024 6:55 am

Thank you for sharing Tony, was planning on doing the same for the front of my +2.
1969 Lotus Elan +2 4 speed - Barn find and currently undergoing recommissioning.
1979 Lancia V6 Group B Rally Car
User avatar
Johnny America
First Gear
First Gear
 
Posts: 49
Joined: 10 Dec 2023
Location: Blewbury England, Cape Coral Florida

Total Online:

Users browsing this forum: snowyelan and 7 guests