back box for my+2S130
16 posts
• Page 2 of 2 • 1, 2
Post by: Hamish Coutts » Mon Dec 05, 2005 4:58 pm
Thor,
The silencer just seemed to fit that way. The whole thing was assembled in position before tightening up any joints or mountings. I have a triangular mounting at the fromt of the silencer so there is not too much choice for how to locate the assembly. Feels like the tailpipe was designed that way.
I don't have any photos to hand but I'll see if I can take a couple tonight and pop them into my gallery.
Regards,
Hamish.
The silencer just seemed to fit that way. The whole thing was assembled in position before tightening up any joints or mountings. I have a triangular mounting at the fromt of the silencer so there is not too much choice for how to locate the assembly. Feels like the tailpipe was designed that way.
I don't have any photos to hand but I'll see if I can take a couple tonight and pop them into my gallery.
Regards,
Hamish.
"One day I'll finish the restoration - honest, darling, just a few more years....."
-
Hamish Coutts - Third Gear
- Posts: 498
- Joined: 29 Jun 2004
16 posts
• Page 2 of 2 • 1, 2
Total Online:
Users browsing this forum: No registered users and 31 guests
Site map
SitemapIndex
RSS Feed