Nader nut KO hex size?

Post by: **danielmo** » Thu Sep 28, 2017 3:29 pm

Does anyone know the hex size of the Nader nuts on the federal Elans? I'm not near a car to physically measure. Thanks, Dan

Post by: **Gordon Sauer** » Thu Sep 28, 2017 6:30 pm

64 mm, 2.5 in Gordon Sauer

Post by: **danielmo** » Thu Sep 28, 2017 6:35 pm

Thank you!

Post by: **StressCraxx** » Thu Sep 28, 2017 11:51 pm

the size is correct, but the Nader Nut is Octagonal, not Hexagonal.

Post by: **danielmo** » Fri Sep 29, 2017 12:34 am

Thanks for clarifying!

Post by: **alan.barker** » Fri Sep 29, 2017 7:01 am

Just measured my special anodised alloy socket for them, 65 mm across flats
Alan

Post by: **CBUEB1771** » Fri Sep 29, 2017 1:14 pm

Gordon Sauer wrote:64 mm, 2.5 in Gordon Sauer

I am willing to bet that the original drawing would have been dimensioned in inches.

Post by: **alan.barker** » Fri Sep 29, 2017 1:53 pm

Sorry so used to metric.