Rim Embellisher Stock v's Paul Matty
2 posts
• Page 1 of 1
Post by: Grizzly » Mon Jul 10, 2017 5:56 pm
Hi all,
Some one asked me a while back what the difference between the original 2 seater wheel trim and the Paul Matty reproduction trims. I forget who asked but i said i'd put some pictures up next time i had one off. It's all minor differences and seem to fit fine/tight even though the valve cut out makes is close to the valve especially if you go tubeless.
Can't see very well due to the chrome but the Matty version has more of a radius to the front face.
Personally i'm happy with them, but not identical to the originals (i wouldn't change just one)
Some one asked me a while back what the difference between the original 2 seater wheel trim and the Paul Matty reproduction trims. I forget who asked but i said i'd put some pictures up next time i had one off. It's all minor differences and seem to fit fine/tight even though the valve cut out makes is close to the valve especially if you go tubeless.
Can't see very well due to the chrome but the Matty version has more of a radius to the front face.
Personally i'm happy with them, but not identical to the originals (i wouldn't change just one)
Chris
-
Grizzly - Coveted Fifth Gear
- Posts: 1862
- Joined: 13 Jun 2010
Post by: alan.barker » Mon Jul 17, 2017 12:50 pm
Are there any available in stainless and at what price
Alan
Alan
Alan.b Brittany 1972 elan sprint fhc Lagoon Blue 0460E
- alan.barker
- Coveted Fifth Gear
- Posts: 3758
- Joined: 06 Dec 2008
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 27 guests
Site map
SitemapIndex
RSS Feed