control arm bushings
3 posts
• Page 1 of 1
I am looking for a company that can supply rubber control arm bushings.
I am looking for a cylindrical bushing with a bonded metal tube at the center only. The tube ID is .370 for a 3/8" bolt OD 1/2") and the outside cylinder diameter (rubber) is .925 (or close) and the length of tube and rubber 1.5". Tube can be a few thousands proud of end of rubber.
The "eyelet" portion of the tubular control arm that accepts the rubber bushing has an ID of .80".
thanks
Bob
I am looking for a cylindrical bushing with a bonded metal tube at the center only. The tube ID is .370 for a 3/8" bolt OD 1/2") and the outside cylinder diameter (rubber) is .925 (or close) and the length of tube and rubber 1.5". Tube can be a few thousands proud of end of rubber.
The "eyelet" portion of the tubular control arm that accepts the rubber bushing has an ID of .80".
thanks
Bob
- rdssdi
- Coveted Fifth Gear
- Posts: 1426
- Joined: 30 Sep 2003
3 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 48 guests