Rear upright ‘plug’
2 posts
• Page 1 of 1
Post by: Lotus54 » Thu Dec 28, 2023 4:26 am
I am properly removing the original spring seats on the rear uprights. The original owner just hacked them halfway off to get clearance.
Just to make sure I do not damage the threads when the damper is out and I am moving the unit around, I made up a 3D printed ‘plug’
I did have to setup up custom threads in Fusion 360, since it has 24tpi and large. But it worked out well and should keep from damaging threads if I do something dumb.
If anyone wants STEP/STL file, I am happy to give away.
Likely nobody needs this, (including me) but since it was easy I figured better to be extra safe.
Mark
Just to make sure I do not damage the threads when the damper is out and I am moving the unit around, I made up a 3D printed ‘plug’
I did have to setup up custom threads in Fusion 360, since it has 24tpi and large. But it worked out well and should keep from damaging threads if I do something dumb.
If anyone wants STEP/STL file, I am happy to give away.
Likely nobody needs this, (including me) but since it was easy I figured better to be extra safe.
Mark
- Attachments
-
Last edited by Lotus54 on Thu Dec 28, 2023 2:08 pm, edited 1 time in total.
1966 Lotus Elan S3- Benelli motorcycles (various)
- Lotus54
- Second Gear
- Posts: 128
- Joined: 10 Oct 2023
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 17 guests
Site map
SitemapIndex
RSS Feed