Rear hub thickness
2 posts
• Page 1 of 1
Post by: h20hamelan » Fri Jun 28, 2019 2:15 am
From wheel mating surface, to bearing/upright mating surface
I am guessing the baby?s rear is near three inches width/thickness
+2 about three and one half inch width/thickness
Yes, I just had mine apart. Unfortunately did not record or think to record this
Could someone please confirm one or the other
Kind Regards
I am guessing the baby?s rear is near three inches width/thickness
+2 about three and one half inch width/thickness
Yes, I just had mine apart. Unfortunately did not record or think to record this
Could someone please confirm one or the other
Kind Regards
Born, and brought home from the hospital (no seat belt (wtf)) in a baby!
Find out where the limits are, and start from there
Love your Mother
Earth
Find out where the limits are, and start from there
Love your Mother
Earth
-
h20hamelan - Coveted Fifth Gear
- Posts: 1968
- Joined: 25 Sep 2010
Post by: elanman999 » Sat Jun 29, 2019 8:17 am
On an Elan hub the wheel mounting face is approx 1.150" from the inboard face, the overall thickness is, as you say 3". And yes, the +2 dimensions will be .5" greater.
Cheers
John
Cheers
John
- elanman999
- Fourth Gear
- Posts: 500
- Joined: 12 Nov 2005
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 42 guests
Site map
SitemapIndex
RSS Feed