early Elan
3 posts
• Page 1 of 1
Post by: GLB » Wed May 22, 2019 9:43 pm
another question about my early Elan 0045. I have the chassis unit stripped and ready to repaint. It is a replacement unit. The Tabs that hold the brake lines on the vacuum tank are missing. Somewhere in the back of my mind I think I remember that the lines on an early car ran at the back of the tank rather than on top. Since I will be replacing brake lines and have to weld on new tabs I might as well put them where they belong. Any help to enlighten me would be appreciated. Gary
- GLB
- Second Gear
- Posts: 191
- Joined: 31 Jan 2018
Post by: Elan45 » Fri May 24, 2019 1:00 pm
Gary,
I have three S3's, the latest one a Super Safety, and all three have the brake line(s) running across the back of the vac chamber/ front cross-member.
Roger
I have three S3's, the latest one a Super Safety, and all three have the brake line(s) running across the back of the vac chamber/ front cross-member.
Roger
'67 Elan S3 SS DHC
'67 Elan FHC pre-airflow
'67 Elan S3 SE upgrade to 26R by Original owner
'58 Eleven S2 (ex-works)
'62 20/22 FJ (ex-Yamura)
'70 Elan +2S RHD
'61 20 FJ project
'76 Modus M1 F3
'67 Elan FHC pre-airflow
'67 Elan S3 SE upgrade to 26R by Original owner
'58 Eleven S2 (ex-works)
'62 20/22 FJ (ex-Yamura)
'70 Elan +2S RHD
'61 20 FJ project
'76 Modus M1 F3
- Elan45
- Fourth Gear
- Posts: 957
- Joined: 23 Nov 2008
3 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 29 guests
Site map
SitemapIndex
RSS Feed