Lotus Elan

flat plate throttle body part Nos

PostPost by: john.p.clegg » Sat Mar 10, 2007 5:04 pm

I have in my possession a flat plate type throttle body which fits the twinc inlets and wondered if anyone could throw any light on it,the part numbers are

01-27-7037
and
01-42-7037a

Thanks in advance

John :wink:
User avatar
john.p.clegg
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 5690
Joined: 21 Sep 2003
Location: Manchester

PostPost by: tdafforn » Sun Mar 11, 2007 2:08 pm

Don't know the numbers, but they sound V. nice..
Is it a tecalamet (sp?) system
When are you going to Donington?
It'd be good to compare ideas about FI and the twincam again. I've got some bike throttle bodies that I am hoping to convert..
Cheers
Tim
User avatar
tdafforn
Fourth Gear
Fourth Gear
 
Posts: 867
Joined: 12 Sep 2003
Location: Kenilworth Warwks.

PostPost by: john.p.clegg » Sun Mar 11, 2007 3:54 pm

Tim
I'm well on the way with the EFI,I'll bring my bits along and see you at the car at 12:00?

John :wink:
White plus 2, VWW 965F
User avatar
john.p.clegg
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 5690
Joined: 21 Sep 2003
Location: Manchester

PostPost by: tdafforn » Sun Mar 11, 2007 5:23 pm

OK doke
User avatar
tdafforn
Fourth Gear
Fourth Gear
 
Posts: 867
Joined: 12 Sep 2003
Location: Kenilworth Warwks.

PostPost by: cliveyboy » Fri Mar 16, 2007 11:38 am

John, Tim
Come and have a chat with me at Donington.
I have just started messing around making up an inlet manifold for bike throttle bodies.
I also have two different old throttle bodies for a twink. One is made by "T J" induction systems. the other unknown one has an angled flange so it bolts to the engine at 45degrees.
I have not got the throttle bodies handy otherwise I could have brought them to Donington to show you.
Clive
1972 Elan Sprint FHC
cliveyboy
Fourth Gear
Fourth Gear
 
Posts: 586
Joined: 22 Sep 2003
Location: Oxfordshire UK

PostPost by: tdafforn » Fri Mar 16, 2007 12:39 pm

Hi Clive,
Will bring the throttle bodies I have (from a CBR600).
I was thinking that a production run of flanges with a stub would probably be a good idea.
Cheers
Tim
User avatar
tdafforn
Fourth Gear
Fourth Gear
 
Posts: 867
Joined: 12 Sep 2003
Location: Kenilworth Warwks.

PostPost by: john.p.clegg » Fri Mar 16, 2007 4:53 pm

Tim,Clive
I'll bring the flat plate throttle body,the bike throttle bodies and the full kit (now finished) ready to bolt to the head which comprises stubs,throttle bodies,ISCV,air flow sensor,air temp sensor,throttle pot,fuel reg,fuel rail etc...etc...

John :wink:
User avatar
john.p.clegg
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 5690
Joined: 21 Sep 2003
Location: Manchester

Total Online:

Users browsing this forum: No registered users and 7 guests