Cylinder head dimensions
4 posts
• Page 1 of 1
Gents
Can someone possibly help out, I would like to know the depth of a standard Weber head (1968)
I have a 1968 Super SE engine which should have 0.04” or 1mm skimmed off to give higher compression, The head is away to come off for decoke, new cams. And I would like to check to see if the head depth is correct.
But alas I don’t know size of standard head to reference from.
Regards
Jason
Can someone possibly help out, I would like to know the depth of a standard Weber head (1968)
I have a 1968 Super SE engine which should have 0.04” or 1mm skimmed off to give higher compression, The head is away to come off for decoke, new cams. And I would like to check to see if the head depth is correct.
But alas I don’t know size of standard head to reference from.
Regards
Jason
- JasonJ
- First Gear
- Posts: 43
- Joined: 27 Mar 2023
4 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 29 guests