Heater valve clearance?
46 posts
• Page 4 of 4 • 1, 2, 3, 4
Post by: Terry Posma » Thu Feb 02, 2017 3:59 pm
Pardon for reviving a thread.
Putting the car back together and I have found the bonnet to cam cover clearance is nil.
Looking at this thread it would appear that the height between the top of the new mounts I have purchased and the bit that attaches to the chassis is 28mm not 23mm as noted in an earlier post.
Can someone advise what the bonnet and cam cover clearance should be and also would it be ok to slot the mount by 5mm?
Cheers.
Putting the car back together and I have found the bonnet to cam cover clearance is nil.
Looking at this thread it would appear that the height between the top of the new mounts I have purchased and the bit that attaches to the chassis is 28mm not 23mm as noted in an earlier post.
Can someone advise what the bonnet and cam cover clearance should be and also would it be ok to slot the mount by 5mm?
Cheers.
- Terry Posma
- Second Gear
- Posts: 95
- Joined: 24 Nov 2003
46 posts
• Page 4 of 4 • 1, 2, 3, 4
Total Online:
Users browsing this forum: DamianB and 25 guests
Site map
SitemapIndex
RSS Feed