cooling system bleeder valve
1 post
• Page 1 of 1
I have been concerned with completely removing air from my cooling system. I was having trouble with the larger custom alloy radiator installed in my +2. I discovered a leak in one of the end tubes. Not easily nor effectively repaired. I chose to install the original radiator which I had recored when I began the restoration but never used.
I purchased a new thermostat housing and had a threaded (10 x 1 mm) bung added and installed a bleeder. I have not ran the car nor purged the system yet but will tomorrow.
Bob
I purchased a new thermostat housing and had a threaded (10 x 1 mm) bung added and installed a bleeder. I have not ran the car nor purged the system yet but will tomorrow.
Bob
- rdssdi
- Coveted Fifth Gear
- Posts: 1426
- Joined: 30 Sep 2003
1 post
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 9 guests