Cam Gears
8 posts
• Page 1 of 1
Post by: l10tus » Fri Apr 24, 2020 12:38 pm
Is there any difference between the Inlet, Exhaust and Jackshaft gears, can they be installed in any of the afforementioned locations?
I have seen gears with EX. Marked on them, so I wonder if there are any real differences?
Replies / thoughts welcomed
I have seen gears with EX. Marked on them, so I wonder if there are any real differences?
Replies / thoughts welcomed
Philip.
UK '72 Sprint DHC
Sometimes my Lotus makes me cry.
UK '72 Sprint DHC
Sometimes my Lotus makes me cry.
-
l10tus - Third Gear
- Posts: 476
- Joined: 10 Apr 2008
Post by: alan.barker » Fri Apr 24, 2020 3:13 pm
The Timing mark is one Tooth different on Exhaust
Alan
Alan
Alan.b Brittany 1972 elan sprint fhc Lagoon Blue 0460E
- alan.barker
- Coveted Fifth Gear
- Posts: 3754
- Joined: 06 Dec 2008
Post by: englishmaninwales » Fri Apr 24, 2020 4:08 pm
The position of the timing marks are different relative to the hole for the camshaft locating pin for inlet and exhaust (by one tooth as Alan says).
Either can be used on the jack shaft.
Malcolm
Either can be used on the jack shaft.
Malcolm
Last edited by englishmaninwales on Fri Apr 24, 2020 10:48 pm, edited 1 time in total.
1966 Elan S3 Coupe
1994 Caterham 7
1994 Caterham 7
- englishmaninwales
- Fourth Gear
- Posts: 710
- Joined: 26 Jul 2013
8 posts
• Page 1 of 1
Total Online:
Users browsing this forum: stugilmour and 21 guests
Site map
SitemapIndex
RSS Feed