O Rings
5 posts
• Page 1 of 1
Post by: jonnyconcrete » Tue Jul 27, 2010 10:38 am
Anyone know the size of the inlet manifold O rings for twin webers?
- jonnyconcrete
- Second Gear
- Posts: 96
- Joined: 21 Jul 2010
Post by: alexblack13 » Tue Jul 27, 2010 12:02 pm
44mm approx I/D and about 3.4mm diameter Poss an Imperial equiv'...
AB...
AB...
Alex Black.
Now Sprintless!!
Now Sprintless!!
-
alexblack13 - Coveted Fifth Gear
- Posts: 2072
- Joined: 17 Oct 2007
Post by: Galwaylotus » Tue Jul 27, 2010 1:21 pm
1 3/4" by 1/8" ?
Mechanical Engineer, happily retired!
'67 S3 SE FHC
See Facebook page: W J Barry Photography
Put your money where your mouse is, click on "Support LotusElan.net" below.
'67 S3 SE FHC
See Facebook page: W J Barry Photography
Put your money where your mouse is, click on "Support LotusElan.net" below.
-
Galwaylotus - Coveted Fifth Gear
- Posts: 1255
- Joined: 01 May 2006
Post by: royrender1 » Tue Jul 27, 2010 7:51 pm
If you put the wrong o rings in they will perish with petrol buy the right ones.
ROY
ROY
- royrender1
- New-tral
- Posts: 9
- Joined: 30 Mar 2010
Post by: Galwaylotus » Wed Jul 28, 2010 6:51 pm
Good point. Get Viton O-rings. They're more expensive but are the best.
Mechanical Engineer, happily retired!
'67 S3 SE FHC
See Facebook page: W J Barry Photography
Put your money where your mouse is, click on "Support LotusElan.net" below.
'67 S3 SE FHC
See Facebook page: W J Barry Photography
Put your money where your mouse is, click on "Support LotusElan.net" below.
-
Galwaylotus - Coveted Fifth Gear
- Posts: 1255
- Joined: 01 May 2006
5 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 30 guests
Site map
SitemapIndex
RSS Feed