Thread size

PostPost by: miked » Thu Sep 20, 2007 7:58 pm

Can anybody tell me the thread size/type for the two holes beneath the thermostat housing. The ones for the heater valve and the temp' gauge sender.


I want to run a tap down them to clean the threads

Thanks Mike :D
User avatar
miked
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 1191
Joined: 29 Sep 2003

PostPost by: elansprint71 » Thu Sep 20, 2007 8:49 pm

Not off the top of my head - but they are taper BSP thread so don't go running a tap right through. Come to think of it, I'm not sure that they are both the same thread, either.

That wasn't much use, was it? :oops:

Cheers,
Pete.
User avatar
elansprint71
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 2624
Joined: 16 Sep 2003

PostPost by: 65 Lotus » Thu Sep 20, 2007 9:37 pm

The forwardmost hole for the temperature bulb fitting is a 3/8-19 BSPP (parallel).

The rearmost hole for the heater valve is 3/8-19 BSPT (taper).
Scott In Ohio
26/3795
65 Lotus
Second Gear
Second Gear
 
Posts: 80
Joined: 24 May 2007

PostPost by: miked » Fri Sep 21, 2007 4:51 pm

Thanks Scott and Pete,

I have a parallel and am sure the father-in-law will have the taper (Retired Plumber).

Mike


:D
User avatar
miked
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 1191
Joined: 29 Sep 2003

Total Online:

Users browsing this forum: No registered users and 30 guests