Tacho woes!
6 posts
• Page 1 of 1
Post by: tdafforn » Mon May 29, 2006 8:23 pm
After reading the thread about replacing old sticking throttle cables with bike cables, I did the same..
However as always one job leads to another, so I ended up replacing the starter solenoid (which had dodgy connections) with a new one...
Worked nicely, and means that the starter turns much faster..
However, now the tacho has gone crazy..
Its fine on startup and for almost exactly 40 seconds then it dies..
If I stop the engine an restart it is fine for 40 seconds and then dies again
The car has an aldon ignitor ignition, and has been working with it for over a year..
Any one have any ideas?
Cheers
Tim
However as always one job leads to another, so I ended up replacing the starter solenoid (which had dodgy connections) with a new one...
Worked nicely, and means that the starter turns much faster..
However, now the tacho has gone crazy..
Its fine on startup and for almost exactly 40 seconds then it dies..
If I stop the engine an restart it is fine for 40 seconds and then dies again
The car has an aldon ignitor ignition, and has been working with it for over a year..
Any one have any ideas?
Cheers
Tim
-
tdafforn - Fourth Gear
- Posts: 744
- Joined: 12 Sep 2003
Post by: triumphelan » Tue May 30, 2006 6:10 am
I to have tacho problem ,on start up I get zero reading in cold weather, its usually fine when it`s warm.After a short time about 5mins it kicks in
Regards John 1969S4DHC
- triumphelan
- Second Gear
- Posts: 195
- Joined: 04 Jul 2005
Post by: triumphelan » Wed May 31, 2006 11:39 am
Thats the best offer I`ve had in a long time XXXXX
Regards John 1969S4DHC
- triumphelan
- Second Gear
- Posts: 195
- Joined: 04 Jul 2005
6 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 13 guests
Site map
SitemapIndex
RSS Feed