Smiths gauge parts-seals,glass, bevels
5 posts
• Page 1 of 1
Hi all,
my Smiths gauges look worse for wear with the rubber seals having oozed out from around the glass. I have to take some of the gauges out for other work, and am wondering where is the best place to get parts such as the seals, and glass (I suspect I will break the glass when I dismantle them), as well as bezels just in case.
my Smiths gauges look worse for wear with the rubber seals having oozed out from around the glass. I have to take some of the gauges out for other work, and am wondering where is the best place to get parts such as the seals, and glass (I suspect I will break the glass when I dismantle them), as well as bezels just in case.
Skittle. 1967 Elan S3 DHC
- skelteanema
- Third Gear
- Posts: 243
- Joined: 11 Dec 2003
the uk has good rebuilders, as does USA
shipping I suppose unless our friends in Aus know of places
shipping I suppose unless our friends in Aus know of places
Born, and brought home from the hospital (no seat belt (wtf)) in a baby!
Find out where the limits are, and start from there
Love your Mother
Earth
Find out where the limits are, and start from there
Love your Mother
Earth
-
h20hamelan - Coveted Fifth Gear
- Posts: 1961
- Joined: 25 Sep 2010
I got seals and bezels from these guys:
https://www.smiths-instruments.co.uk/
I had to email them with a list of requirements.
https://www.smiths-instruments.co.uk/
I had to email them with a list of requirements.
Graeme
S4 SE
S2 GTS
Caterham 420R
Sold - Peterson JPS Exige
S4 SE
S2 GTS
Caterham 420R
Sold - Peterson JPS Exige
-
661 - Coveted Fifth Gear
- Posts: 1195
- Joined: 29 Mar 2012
There are a number of people advertising all the parts you need on eBay. I refurbished all of my instruments without too much bother.
Look on the back of each gauge and you should see some small bent over parts of the bezel, carefully lever these back until the gauge comes away from the glass etc. You may need to try and rotate the bezel on the gauge to free it up.
Give all a good clean and reassemble. Make sure you put either a thick card or a piece of hardboard across front of intrument when bending the bezel back into position, so you can keep pressure on the gauge. This will ensure the bezel does not end up with any marks. You can also rest the gauge on a table top to hold it square whilst bending the bezel to the rear of the instrument.
Tony
Look on the back of each gauge and you should see some small bent over parts of the bezel, carefully lever these back until the gauge comes away from the glass etc. You may need to try and rotate the bezel on the gauge to free it up.
Give all a good clean and reassemble. Make sure you put either a thick card or a piece of hardboard across front of intrument when bending the bezel back into position, so you can keep pressure on the gauge. This will ensure the bezel does not end up with any marks. You can also rest the gauge on a table top to hold it square whilst bending the bezel to the rear of the instrument.
Tony
- tonyabacus
- Third Gear
- Posts: 435
- Joined: 16 Sep 2003
5 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 17 guests