Horn help, turn signal high beam arm

[h20hamelan]

I am still looking at grounds

any help/ thoughts etc

regards

[AussieJohn]

Not sure what you are asking but the column is earthed at the bottom of the column by a strap across the UJ at the pinion.

[h20hamelan]

sorry, not so clear!

My horn is in the turn signal arm.
I get no current or connection between the end (two contact points) and the column.
there is a current path between the column and horn.

I will close the circuit with a better ground
i also suspect the horn is dead, so i will fit a electric horn for a test

I would like to rebuild the wiring for the arm so the original arm works
I don't mind spending $60 or so for a used one. But what is to say a used one would work...

thanks

[Galwaylotus]

sorry, not so clear!

My horn is in the turn signal arm.

Is it from a Mini? If so you can probably get a new one from Mini Spares without breaking the bank!
Looks like your location is in Kent so no shipping problems!!

[h20hamelan]

located in Canada
Standard Post not so bad

[h20hamelan]

Oh
and
Thanks! Galwaylotus