quarter light channels

[bob_rich]

Hi Folks

I suspect a few of U have seen the horror stories in the pictures below! A mate of mine managed the fill the one with braze but the other was too far gone ( for his considerable skills). Looking for someone who could remake these or is very delicate with the braze/silver solder so that one badely damaged one could be filled prior to re-plating. Any one know someone who does these or possibly a source of them?

cheers and of course seasons greetings!!

regards

Bob

[mikealdren]

Paul Mallinson did a line in stainless channels a few years ago, there may still be some around.

Mike

[jono]

Bob,

I have one of the stainless remakes spare - passenger side only.

PM if interested - have it for what I paid (?30)

Jon

[DavidLB]

I'm pretty sure that vincent Haydon is having some made, if not I know where some can be made providing you have a pattern
David B

[Jason1]

Hi Bob

They do not look too bad; could you not braze a small plate underneath?

B&Q sell MAP gas and braze sticks.

http://www.diy.com/nav/fix/handtools-st ... r-11248052

http://www.diy.com/nav/fix/handtools-st ... k-11248050


Jason

[bob_rich]

Thanks for the replies folks

regarding brazing up the guy who tried is very skilled. He does all sorts of brazing for specialist components used in the electronics industry. Problem is the pictures dont convey just how thin the remaining metal is and it tends to melt / burn way as the flame is applied.

I have bought Jono's passenger side one and so will still keep looking for a drivers side one so still looking for a source of build.

thanks 4 help seasons greetings to all on this excellent forum

regards

Bob