Wiring a voltmeter

PostPost by: Greg Foster » Fri Feb 05, 2010 7:37 pm

I have just installed an alternator in my 67 elan. The dash had an ammeter which I will be exchanging for a volt meter. What color of wire should I us to be in keeping with std. british wiring and where should I draw this wire from?
Greg
'67 s3 SS
'72 +2 S130
Greg Foster
Second Gear
Second Gear
 
Posts: 219
Joined: 15 Sep 2003

PostPost by: bast0n » Fri Feb 05, 2010 8:06 pm

Anything that is long enough to connect at both ends!
David
bast0n
Third Gear
Third Gear
 
Posts: 306
Joined: 31 Oct 2008

PostPost by: neilsjuke » Fri Feb 05, 2010 11:11 pm

Green = accessories via ignition switch
Neil
neilsjuke
Third Gear
Third Gear
 
Posts: 359
Joined: 29 Oct 2007

PostPost by: Greg Foster » Sat Feb 06, 2010 1:37 am

Thank you Neil.
Green seemed logical but I wasn't sure if there was a tracer color related to it.

Greg
'67 s3 SS
'72 +2 S130
Greg Foster
Second Gear
Second Gear
 
Posts: 219
Joined: 15 Sep 2003

PostPost by: Frank Howard » Sat Feb 06, 2010 5:39 am

neilsjuke wrote:Green = accessories via ignition switch
Neil

And black to any convenient ground.
Frank Howard
'71 S4 SE
Minnesota
Frank Howard
Fourth Gear
Fourth Gear
 
Posts: 919
Joined: 30 Mar 2004

PostPost by: Mr.Gale » Sun Feb 07, 2010 5:45 pm

Why do you want to switch to a voltmeter? The ammeter will still work with an alternator and indicate if the system is charging or not.

Mr.Gale
Mr.Gale
Second Gear
Second Gear
 
Posts: 141
Joined: 08 Sep 2009

PostPost by: robertverhey » Sun Feb 07, 2010 9:06 pm

I have both ammeter and voltmeter fitted and must admit I find the voltmeter more useful and consult it more often. As the accessories gradually get switched on (lights, wipers, blower fan, aircon), it gives an indication whether we're still charging. Conversely, the ammeter seems to read more into the positive, the more load I place on it.....which doesn't tell me much.
robertverhey
Fourth Gear
Fourth Gear
 
Posts: 695
Joined: 20 Feb 2007

PostPost by: Greg Foster » Sun Feb 07, 2010 10:12 pm

The reason I am installling the voltmeter and removing the ammeter; the P.O. had cut into the dash panel to the right and slightly higher than the center of the ash tray. The ammeter was backed tightly against the heater box under the dash. I disconnected it when I rebuilt my dash and wiring as I had the fear of the ammeter arcing against the heater box. So it wasn't operating and now I have changed to an alternator. The voltmeter looks the part, fills the hole, and actually works!
Greg
'67 s3 SS
'72 +2 S130
Greg Foster
Second Gear
Second Gear
 
Posts: 219
Joined: 15 Sep 2003

PostPost by: msd1107 » Sun Feb 07, 2010 11:21 pm

An ammeter and volt meter serve two complementary purposes.

An ammeter indicates if the charging circuit is sending excess current to the battery. However, if the battery is faulty, even though it is being charged, it still may not function properly.

A volt meter can give you an advance warning of a faulty battery. Generally, you will see a depressed voltage reading on other than no load charging conditions. For instance, on switch on, idle, night time at low rpm, etc. Startup always depresses the voltage, but you will notice as the voltage decreases more during the life of the battery.

Having both instruments are best, but very few vehicles are so equipped.

David
1968 36/7988
User avatar
msd1107
Fourth Gear
Fourth Gear
 
Posts: 770
Joined: 24 Sep 2003

Total Online:

Users browsing this forum: No registered users and 28 guests