Drive shaft lengths
8 posts
• Page 1 of 1
Post by: tonyabacus » Sun May 29, 2022 10:58 am
With so many variations of shafts available, some with donuts others with a variety of other joints, are the basic shafts the same between an Elan an a +2
- tonyabacus
- Third Gear
- Posts: 435
- Joined: 16 Sep 2003
Post by: tonyabacus » Sun May 29, 2022 2:40 pm
Thanks guys, looks like both of you replied at the same time.
- tonyabacus
- Third Gear
- Posts: 435
- Joined: 16 Sep 2003
Post by: h20hamelan » Sun May 29, 2022 5:58 pm
The 5 speed are different for both again, thou duh & of course
12” approx
Back of engine block to diff flange is 68” minus 5 speed box & bell @ 26”
12” approx
Back of engine block to diff flange is 68” minus 5 speed box & bell @ 26”
Born, and brought home from the hospital (no seat belt (wtf)) in a baby!
Find out where the limits are, and start from there
Love your Mother
Earth
Find out where the limits are, and start from there
Love your Mother
Earth
-
h20hamelan - Coveted Fifth Gear
- Posts: 1968
- Joined: 25 Sep 2010
Post by: elans3 » Sun May 29, 2022 6:34 pm
Err, the O.P was talking about the drive shafts I believe (diff to rear hubs), not the propshaft.
Current :- Elan S3 DHC SE S/S 1968,
1963 Alfa Giulia Ti Super Rep.
Previous :-
Elan S3 DHC SE SS 1968,
Elan S3 DHC S/E 1966
Elan S3 FHC Pre-Airflow 1966
1963 Alfa Giulia Ti Super Rep.
Previous :-
Elan S3 DHC SE SS 1968,
Elan S3 DHC S/E 1966
Elan S3 FHC Pre-Airflow 1966
- elans3
- Fourth Gear
- Posts: 525
- Joined: 12 Sep 2003
Post by: mbell » Sun May 29, 2022 7:47 pm
elans3 wrote:Err, the O.P was talking about the drive shafts I believe (diff to rear hubs), not the propshaft.
This is a us v UK thing, prop shaft is commonly called drive shaft in the US.
'73 +2 130/5 RHD, now on the road and very slowly rolling though a "restoration"
- mbell
- Coveted Fifth Gear
- Posts: 2643
- Joined: 07 Jun 2013
8 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 21 guests
Site map
SitemapIndex
RSS Feed