Pedal box - limit screw for clutch master cylinder pedal
2 posts
• Page 1 of 1
Dear All,
I have the pedal box out to change the seals in the clutch and brake master cylinders. When refitting the clutch pedal clevis pin to the push rod I noticed this adjusting screw for the first time. I have wound it out about 10 mm from its original position - hard to move, and looked like it might have been Loctited originally.
Can anyone hep me with setting advice please ?
--- or is it redundant ? no mention in the +2 workhsop manual.
Thanks and Best Wishes,
Dick
I have the pedal box out to change the seals in the clutch and brake master cylinders. When refitting the clutch pedal clevis pin to the push rod I noticed this adjusting screw for the first time. I have wound it out about 10 mm from its original position - hard to move, and looked like it might have been Loctited originally.
Can anyone hep me with setting advice please ?
--- or is it redundant ? no mention in the +2 workhsop manual.
Thanks and Best Wishes,
Dick
- dick+2130/5
- First Gear
- Posts: 26
- Joined: 28 Jul 2011
Yes, it limits the clutch pedal "fully pressed" position, so that the master / slave cylinder doesn't get over actuated. Definitely not redundant.
-
JonB - Coveted Fifth Gear
- Posts: 2115
- Joined: 14 Nov 2017
- Location: South Coast, UK
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 5 guests