Door locked in situ
2 posts
• Page 1 of 1
Hi All,
Working on my plus 2 and adjusted the passenger door closing latch to make the door fit flush and now cannot open the door using either the door latch or internal release.
any ideas on how to overcome this, thought of trying to remove the door card and see whats happend?
Steve
Working on my plus 2 and adjusted the passenger door closing latch to make the door fit flush and now cannot open the door using either the door latch or internal release.
any ideas on how to overcome this, thought of trying to remove the door card and see whats happend?
Steve
- potleyu18
- Second Gear
- Posts: 66
- Joined: 17 Oct 2012
push the door and then press the button...the spring is holding the latch on the hoop because it is too tight
had the same when i replaced the rubber seals, they push the door out slightly
had the same when i replaced the rubber seals, they push the door out slightly
-
LaikaTheDog - Third Gear
- Posts: 333
- Joined: 29 Oct 2003
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 31 guests