Replacing Dashboard on early model +2
31 posts
• Page 3 of 3 • 1, 2, 3
Post by: berni29 » Mon Jan 15, 2007 8:57 am
Hi There
This is a bit late on this thread, but I would always replace the heater matrix with a modern one if taking the dash out. And replace the hoses. On the LED question, I found that for stop / indicator lights the visibility was heavily reduced angle wise. Fine straight on though. Also the flasher unit has to be changed for a modern one, or a resistor used with the lights.
Modern extra bright halogen bulbs for the headlights are enough surely?
All the best
Berni
This is a bit late on this thread, but I would always replace the heater matrix with a modern one if taking the dash out. And replace the hoses. On the LED question, I found that for stop / indicator lights the visibility was heavily reduced angle wise. Fine straight on though. Also the flasher unit has to be changed for a modern one, or a resistor used with the lights.
Modern extra bright halogen bulbs for the headlights are enough surely?
All the best
Berni
Zetec+ 2 under const, also 130S. And another 130S for complete restoration. Previously Racing green +2s with green tints. Yellow +2 and a couple of others, all missed. Great to be back 04/11/2021 although its all starting to get a bit out of control.
-
berni29 - Fourth Gear
- Posts: 822
- Joined: 10 Mar 2004
31 posts
• Page 3 of 3 • 1, 2, 3
Total Online:
Users browsing this forum: No registered users and 34 guests
Site map
SitemapIndex
RSS Feed