steering rack shims
17 posts
• Page 2 of 2 • 1, 2
MACCA.GLM wrote:Hi
I am going to try to find a way to measure the height with the body still on. I have a Five foot grade a straight edge which I think I can get in to take some measurements and see if the 2.19 inches is somewhere near.I think the rack will have to come off to facilitate this so might take some time.
Regards
G
G.. Sorry don't know what G is short for;-
To my way of thinking it would be better to do a proper geometry check first?
Doing a lot of work to obtain that measurement seems a lot of work to me and if it doesn't measure what you hope for you will still have to do the geometry check afterwards...
Alan.
Alan
'71 +2 S130/ 5speed Type9.
'71 +2 S130/ 5speed Type9.
- alanr
- Coveted Fifth Gear
- Posts: 1005
- Joined: 14 Sep 2018
Hi Alan,
Sorry, I didn't mean to imply that you should change anything with your setup.
A pet project of mine is modelling in CAD the front suspension and one of the elusive parts is determining what the bump toe (if any) was from the factory. I also failed to see that you have a +2 so the geometry will be different to what I have modelled.
Sorry, I didn't mean to imply that you should change anything with your setup.
A pet project of mine is modelling in CAD the front suspension and one of the elusive parts is determining what the bump toe (if any) was from the factory. I also failed to see that you have a +2 so the geometry will be different to what I have modelled.
Scott
45/9011
Hawkestone, On, Ca
45/9011
Hawkestone, On, Ca
- snowyelan
- Fourth Gear
- Posts: 500
- Joined: 14 Sep 2003
17 posts
• Page 2 of 2 • 1, 2
Total Online:
Users browsing this forum: No registered users and 15 guests