Weber head in US (SOLD)
1 post
• Page 1 of 1
SOLD This head is in Macomb, Michigan, USA. $1600 OBO plus shipping..
I had it as a spare from the 80s, but never used it.
At one end of the head LP 3528 is stamped in. Not sure what that means.
Have all of the cam bearing caps, but not all of the studs.
As a check for porosity, I got it pressure tested last week at 50 psi and it didn't leak. Thickness is 4.64 inches so I don't think it was ever skimmed.
to use it I would have new valve seats and valve guides installed.
No camshafts available.
Let me know if you need any more photos or information.
Will also have a Stromberg head with the carbs from the S4 Federal Elan that I used to have.
Bob
I had it as a spare from the 80s, but never used it.
At one end of the head LP 3528 is stamped in. Not sure what that means.
Have all of the cam bearing caps, but not all of the studs.
As a check for porosity, I got it pressure tested last week at 50 psi and it didn't leak. Thickness is 4.64 inches so I don't think it was ever skimmed.
to use it I would have new valve seats and valve guides installed.
No camshafts available.
Let me know if you need any more photos or information.
Will also have a Stromberg head with the carbs from the S4 Federal Elan that I used to have.
Bob
Bob
1969 S4
1969 S4
- lotocone
- Third Gear
- Posts: 418
- Joined: 09 Feb 2010
- Location: Michigan
1 post
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 3 guests