Fuel line size
4 posts
• Page 1 of 1
Post by: pauljones » Mon Mar 19, 2012 9:11 pm
Hi all
Just another quick question, The EFI is being installed in my elan. It should be running no more than 150 bhp. I'm using a bosche inline fuel pump but unsure what size I need for the feed and return. Also the routing for the lines.
Any advice gentlemen?
Paul
Just another quick question, The EFI is being installed in my elan. It should be running no more than 150 bhp. I'm using a bosche inline fuel pump but unsure what size I need for the feed and return. Also the routing for the lines.
Any advice gentlemen?
Paul
Kick the tyres and light them fires...!!!!!!!
- pauljones
- Fourth Gear
- Posts: 828
- Joined: 09 Feb 2008
Post by: bcmc33 » Tue Mar 20, 2012 12:18 am
I used 8mm because I had plenty at hand. If you need to buy it, 6mm will be more than adequate.
Routing was lower RH corner of the centre box section.
Routing was lower RH corner of the centre box section.
Brian Clarke
(1972 Sprint 5 EFI)
Growing old is mandatory..........Growing up is optional
(1972 Sprint 5 EFI)
Growing old is mandatory..........Growing up is optional
-
bcmc33 - Coveted Fifth Gear
- Posts: 1708
- Joined: 10 Apr 2006
Post by: bcmc33 » Tue Mar 20, 2012 2:23 pm
pauljones915 wrote:Thanks I thought as much. Did you have any problems routing from the tank? It looks like I'll have to lift the body off but I don't really want too.
Paul,
Completing a route to the tank was a little more involved, but if you lift the body off the frame then it becomes a lot more simple.
I'll PM some pictures for you to get a better idea.
Brian Clarke
(1972 Sprint 5 EFI)
Growing old is mandatory..........Growing up is optional
(1972 Sprint 5 EFI)
Growing old is mandatory..........Growing up is optional
-
bcmc33 - Coveted Fifth Gear
- Posts: 1708
- Joined: 10 Apr 2006
4 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 21 guests
Site map
SitemapIndex
RSS Feed