1965 Lotus Elan assembly required SOLD

Post by: **zagato4r** » Fri May 01, 2015 6:56 pm

1965 Lotus Elan #3989 with Spyder chassis #1495. I have been working on this car off and on for the last 5 years and have decided that my advancing age and lack of ambition necessitates its sale.The body and chassis are currently separate, but I can mount the body to facilitate transport.The car come with a factory hardtop and soft top. The following are some details:

Engine- Complete rebuild, mains and rods +.010, block surfaced .024, head surfaced .012. The block is a 701M6015 #4SM134, the head is #LB3630
Calipers rebuilt with stainless pistons and new pads
British Wire harness front and rear (not installed)
New distributor, coil and plug wires from RD Ent
New electric fuel pump from RD Ent
New compact alternator from RD Ent
New clutch disc and ring gear
New hard brake lines
Sill reinforcements repaired
Dash is very good refinished original
Seats are in fair condition, the interior will require restoration
Windscreen has wiper scratches and pitting, comes with new gasket and chrome trim
Paint is ok with some fish eyes and light crazing, the car was originally blue
Fuel tank is a replacement with some light interior surface corrosion
All door, window and trunk hardware is with the car
The Spyder chassis includes the roll over bar and side intrusion bars
Please contact me for more details: [email protected]" target="_blank" target="_blank" target="_blank
The car is located in Cortland, NY approx 30 miles south of Syracuse
Photos can be found at:
https://plus.google.com/photos/10636221 ... 3881137761
Asking $23,500.