1971 Lotus Elan+2
3 posts
• Page 1 of 1
Post by: igniteperform » Tue Jan 07, 2014 8:33 pm
Fresh all steel 1600cc. Engine, Less than one hour run time, JE pistons, H-beam rods, Weber carbs, MSD ignition, Tilton dry sump pump, Peterson oil tank, 13.5:1 compression, 162HP at the wheels. 7.25? quarter master clutch, BD flywheel, New Quaife LSD not installed, Full roll cage, Kirkey road race seat. Show car quality ready to race.
A very complete restoration. ($35,000)
Call Greg at Ignite Performance for more information
720-542-3762 [email protected]
A very complete restoration. ($35,000)
Call Greg at Ignite Performance for more information
720-542-3762 [email protected]
- Attachments
-
Last edited by igniteperform on Wed Apr 16, 2014 7:03 pm, edited 2 times in total.
- igniteperform
- New-tral
- Posts: 4
- Joined: 07 Sep 2012
Post by: peterako » Wed Jan 08, 2014 1:42 pm
Drool.......
I is an Inginear....please excuse my speeling!
'73 +2S 130/5
Scimitar GTE for the lazy days, 3008, Some bicycles, Wife, Kids, Cats, Dogs....chickens....cluck cluck...one duck...the others flew away!
'73 +2S 130/5
Scimitar GTE for the lazy days, 3008, Some bicycles, Wife, Kids, Cats, Dogs....chickens....cluck cluck...one duck...the others flew away!
-
peterako - Fourth Gear
- Posts: 701
- Joined: 02 Mar 2006
- Location: A (windy) bog in Ireland
Post by: rgh0 » Wed Jan 08, 2014 10:17 pm
igniteperform wrote:Fresh all steel 1600cc. Engine, .... 162HP at the wheels......
Now that is a serious 1600cc twin cam even if the dyno was a little on the optimistic side I suspect!!!
cheers
Rohan
-
rgh0 - Coveted Fifth Gear
- Posts: 8991
- Joined: 22 Sep 2003
- Location: Melbourne, Australia
3 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 4 guests
Site map
SitemapIndex
RSS Feed