S4 door handle question
1 post
• Page 1 of 1
I took my car to an interior specialist today to get a quote for replacing the drivers side floor carpet (oddly the only part of the carpet showing any wear).
The guy who helped me gorilla'd the passenger's door handle button and the button stuck in.
When I got home I pulled the handle out and the plastic rod that goes from the button out to the lever was broken. It clearly had been over extended and caught on the lever. I also noticed that the roll pin had popped out of one side.
Anyone else had this same or similar issue?
I did see some old looking cracks in the plastic rod from the adjuster screw.
I made a new plastic rod in the lathe and installed a new longer roll pin with the ends peened. It's fixed now.
Here's a pic of the broken part.
The guy who helped me gorilla'd the passenger's door handle button and the button stuck in.
When I got home I pulled the handle out and the plastic rod that goes from the button out to the lever was broken. It clearly had been over extended and caught on the lever. I also noticed that the roll pin had popped out of one side.
Anyone else had this same or similar issue?
I did see some old looking cracks in the plastic rod from the adjuster screw.
I made a new plastic rod in the lathe and installed a new longer roll pin with the ends peened. It's fixed now.
Here's a pic of the broken part.
'70 S4 Elan - Cosworth BDP & Spyder Chassis
'62 S2 Super Seven Cosworth
'62 S2 Super Seven Cosworth
- disquek
- Second Gear
- Posts: 153
- Joined: 25 Oct 2018
- Location: USA - Philadelphia
1 post
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 14 guests