Issue 18 stepped bearing
16 posts
• Page 2 of 2 • 1, 2
Post by: andyhodg » Thu Jul 22, 2010 7:53 pm
John
Have you thought about cutting up feeler gauge blades? From memory I think they should be wide enough. If you do fancy machining the spiders. You would be welcome to come over and borrow my lathe. (I'm in Solihull)
Regards
Andy
Have you thought about cutting up feeler gauge blades? From memory I think they should be wide enough. If you do fancy machining the spiders. You would be welcome to come over and borrow my lathe. (I'm in Solihull)
Regards
Andy
-
andyhodg - Third Gear
- Posts: 350
- Joined: 11 Oct 2005
16 posts
• Page 2 of 2 • 1, 2
Total Online:
Users browsing this forum: No registered users and 16 guests
Site map
SitemapIndex
RSS Feed