NUTS
5 posts
• Page 1 of 1
Post by: twincamman » Wed Aug 18, 2010 1:31 am
I'm looking for wheel nuts for the Elan ----over all length 55.16 mm ----------- length of shank from the bottom of the nut to the end 42.56 mm -------- and the shank diameter 18.5mm --there are lots of these type of nuts that are shorter but I cant find SUPPLIER FOR THE LONG ONES. ANY HELP OUT THERE??????]driving the bags off it - 
--]-ed
--]-ed- Attachments
-
- nut.jpg (9.26 KiB) Viewed 1357 times
dont close your eyes --you will miss the crash
Editor: On June 12, 2020, Edward Law, AKA TwinCamMan, passed away; his obituary can be read at https://www.friscolanti.com/obituary/edward-law. He will be missed.
Editor: On June 12, 2020, Edward Law, AKA TwinCamMan, passed away; his obituary can be read at https://www.friscolanti.com/obituary/edward-law. He will be missed.
-
twincamman - Coveted Fifth Gear
- Posts: 2453
- Joined: 02 Oct 2003
Post by: richard sprint » Wed Aug 18, 2010 9:28 am
Have you considered asking a small machine shop to make them for you?
- richard sprint
- Third Gear
- Posts: 297
- Joined: 02 Feb 2009
Post by: twincamman » Fri Aug 20, 2010 4:39 pm
WELLLL i found them at mini mania ----special order- 10 bucks a piece [ just in case anyone else has 6 inch bolt on mini lites on their 26R --] ed
Last edited by twincamman on Fri Aug 20, 2010 4:43 pm, edited 1 time in total.
dont close your eyes --you will miss the crash
Editor: On June 12, 2020, Edward Law, AKA TwinCamMan, passed away; his obituary can be read at https://www.friscolanti.com/obituary/edward-law. He will be missed.
Editor: On June 12, 2020, Edward Law, AKA TwinCamMan, passed away; his obituary can be read at https://www.friscolanti.com/obituary/edward-law. He will be missed.
-
twincamman - Coveted Fifth Gear
- Posts: 2453
- Joined: 02 Oct 2003
5 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 21 guests
Site map
SitemapIndex
RSS Feed