K & N
3 posts
• Page 1 of 1
Post by: Jens » Sun Nov 12, 2006 9:10 pm
The air box on the +2 has a bracket for
the throtle cable, i would like to fit
K&N filters - what do i do with the cable
bracket.
cheers jens
the throtle cable, i would like to fit
K&N filters - what do i do with the cable
bracket.
cheers jens
-
Jens - Second Gear
- Posts: 181
- Joined: 08 Sep 2004
- Location: Bussum, the Netherlands
Post by: elansprint71 » Sun Nov 12, 2006 11:02 pm
Jens,
You need to fabricate a bracket which spans the gap between the carbs
and provides the anchor point for the outer throttle cable. On my car
this has been rather crudely made (by DPO) from scratch, rather than by
chopping bits from the airbox.
Cheers,
Pete.
You need to fabricate a bracket which spans the gap between the carbs
and provides the anchor point for the outer throttle cable. On my car
this has been rather crudely made (by DPO) from scratch, rather than by
chopping bits from the airbox.
Cheers,
Pete.
-
elansprint71 - Coveted Fifth Gear
- Posts: 4417
- Joined: 16 Sep 2003
- Location: Cheshire, UK.
Post by: rdssdi » Sat Nov 18, 2006 3:14 pm
I have added individual K & N filters to my +2.
They offer a "knock out" at the on the backing plate where a nylon elbow is
attached for crankcase ventilation. Should I run vent lines to both carbs or
only one?
Bob
1969 Elan +2
They offer a "knock out" at the on the backing plate where a nylon elbow is
attached for crankcase ventilation. Should I run vent lines to both carbs or
only one?
Bob
1969 Elan +2
- rdssdi
- Coveted Fifth Gear
- Posts: 1426
- Joined: 30 Sep 2003
3 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 4 guests
Site map
SitemapIndex
RSS Feed