Lotus Elan

LotusElan.net Unified Search

Search results for: tacho in category "Electrical / Instruments"

294 results found.

20 pages of results.
Sorted by relevance / Sort by date
This article shows how to convert a factory RB106 voltage control box into a dummy box for use with a Dynamator, DynaLite, Dynator, etc. A ...
... smaller Dynamator Field tab directly to one tab on the charge warning light in your tacho, or for a more authentic look, to the control box ?F ...
Terms matched: 1  -  Score: 38  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=39678
Is it possible (feasible) to remove/replace the tachometer with the dash in situ? I don't want to remove the whole instrument panel unless avbsolutely necessary ...
... costs? According to their website....from ?55 for speedo and from ?65 for tacho (+ VAT and carriage.) I've removed, cleaned and lubricated the cable ...
Terms matched: 1  -  Score: 38  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=23025
Just about to buy some electronic ignition for my S4 and I wonder how they drive the rev counter? With the points I guess there ...
... thread, and others, I asked the question regarding the need to modify the tacho. They said ?no modification necessary? . So, to satisfy my ...
Terms matched: 1  -  Score: 38  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=14628
OK OK, it seems the only explanation. Installed Pertronix system less than 100 miles ago. Coincidentally, though the car ran well, the tach seemed to ...
... CONDENSER -for these cars and forget the space age junk --ed twincamman As the standard tacho only has a loop through' connection of the ignition supply wire, it ...
Terms matched: 1  -  Score: 38  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=24131
Been fixing recommissioning snags over last few weekends My fuel gauge wasn’t working ! First problem was it wasn’t grounded - easy fix. The next ...
... to be grounded. Original stabilizers happen to be grounded because they're screwed to the tacho, but that's by-the-by. Nick (Heck, I hope this is right ...
Terms matched: 1  -  Score: 38  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=53298
Hi, I am near the end of my Elan S4 FHC rebuild but I have a Rev Counter issue which I am hoping the forum ...
... to calibrate it on the vehicle to try find a suitable calibration point. The Tacho is set up for points through a dual connection, I was told. ...
Terms matched: 1  -  Score: 38  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=53581
Hi all, Just started the process of trying to get the engine started after some 4 years of getting the car rebuilt. I have done ...
... ) and installed ballast resistor to coil with white wire fitted to ballast from the tacho. The voltages measured are 12v from solenoid to coil is 7.9v and 12v ...
Terms matched: 1  -  Score: 38  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=15468
Does anyone have the correct part # for a 1967S3 tachometer ( single digit type + earth)) There appears to be a change from the ...
... in Burnley 1967 S3SE DHC ericbushby Thanks Eric. Yours appears to be the right Tacho and the RVI is correct. But it is the numbers under the pointer ...
Terms matched: 1  -  Score: 36  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=52539
I may have capacitor issue on my 71 tachometer, are there any simple steps out there to replace. It has been bouncy for years, I ...
... on start up, steadies and then dies. Thanks street First check Earth on Tacho Body. The tacho is held in Dash by a Bracket and round knurled ...
Terms matched: 1  -  Score: 36  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=49782
The electronic tach on my '72 Sprint swings wildly under acceleration. I assume it's a bad ground. Anyone know where I should look first?
... go searching. I have literally just come in from the garage having put the tacho back into my Sprint. Even after changing to electronic ignition years ago it ...
Terms matched: 1  -  Score: 36  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=23048
Hi all, An interesting (for me) electrical gremlin which I'd appreciate your wisdom. I have no lights on the dash or tachometer or indicators. However ...
... off. The indicators /flashers units don't need an earth to work and the tacho problem could be an earth, + 12V power feed or the pick up ...
Terms matched: 1  -  Score: 36  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=36068
Hi I'm in the process of a complete rebuild of my 1970 Elan S4 SE. I took the car apart many years ago and always ...
... were all S4s negative earth? I know there could be a problem with the tacho and coil and possibly the dynamo if I get it wrong. Is there ...
Terms matched: 1  -  Score: 36  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=50823
Hi All this past weekend I took the car to its first swap meet and show. The car ran well and the only issue discovered ...
... much appreciated. Darren DJThom Darren Could be a "mechanical" problem within the tacho mechanism...something sticking.. and the only way to check is to take it apart and ...
Terms matched: 1  -  Score: 36  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=16423
If I remove the rev counter for repair, what do I do with the wires that are attached to the back, so that I can ...
... , mine included, the white wire is not in two pieces joined at the tacho, it is one piece which is threaded in a loop around the metal ...
Terms matched: 1  -  Score: 36  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=31448
Hello folks I dont understand the voltage regulator connection in the circuit diagram. Attached is a photograph, the red circled connection confuses me, what is ...
... this do they? The only other I can think of which might is the tacho. Could the confusing connection be just this? Bob Attachments bloodknock Sorry folks ...
Terms matched: 1  -  Score: 36  -  URL: https://lotuselan.net/forums/viewtopic.php?f=38&t=39866
Result Pages: << Previous 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Next >>


Search took 0.152 seconds