LotusElan.net Unified Search
Search results for: tacho in all categories
574 results found.
Refine your search by category:
- Classifieds (38)
- Mailing List Archive (59)
- General (56)
- Body / Chassis / Frame (12)
- Drive Train / Gearbox / Final Drive (5)
- Electrical / Instruments (294)
- Engine / Exhaust / Cooling (84)
- Racing (2)
- Mods (22)
- Misc. (2)
39 pages of results.
Sorted by relevance / Sort by date
151. Help (Again) : Mods - Page 2 by LotusElan.net [Mods]
Hi Again Paul For my fuel feed I am using the arrangement that Spyder use. I got all the bits from them. As I completely ...
... by a simple overhaul and replace all the coil >points>ignition switch>tacho feed wires with new wiring external to the existing loom. I have attached ...
Hi there, Started running in my sprints engine this sunny weekend and have a slight problem.........I want to go slower!!!! Ok the problem is that ...
... type26owner Keith, Thanks for the reply. One problem at the moment, my tacho is not working as I have fitted an electronic ignition (aldon) . ...
153. Mobelec ignition system : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi I have an S4 Elan that has been fitted with a Mobelec ignition system. The ignition part works very well but I can't get ...
... Electronic ignition site:Lotuselan.net] and then pore through the results. and [ tacho site:lotuselan.net] and then pore through the results. and [tachometer ...
154. Anti Theft Switch Location? : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi All, I'm a brand new first time Lotus owner, having just in February bought a 70 Elan from California (I'm in Louisiana). I sure ...
... help. Cheers, Rick hubrick Hi Rick, Assuming you have the later type tacho, the two bullet connectors shown in the wiring diagram are actually connected directly ...
155. Rev Counter Damage from Reverse Polarity : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
I have a stock Elan S3 - positive earth. I accidentally wired the battery for negative earth. Car runs fine, however, no rev counter. Have ...
... . http://www.mgb-stuff.org.uk/harvit.htm billwill I replaced the majority of my tacho internals, wasn't terribly hard and it runs very well now. I put ...
156. S4 Autosparks dash loom : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
I think I am pushing my luck here! I have successfully wired up the front and rear looms but have a problem with the dash ...
... . My car is a late 68 negative earth. On the back of the tacho (RVI 2410/04) there is the small coiled wire (white ...
157. Electronic Ignition : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi, Now I have decided to take the carbs off my +2 and overhaul them myself, I thought I should look into the possibility of ...
... opto ignition system fitted for the last 12years on my Elan Sprint. However the Tacho is inaccurate. Other than that no problems. Regards ROBATGLYN2000 I have an ...
158. indicator or blinker speed : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi all, Im having difficulty finding the reason my indicators flash very slowly at idle and faster at higher revs. It's the same for both ...
... ] I believe this is just to regulate the voltage to the fuel guage & Tacho to keep them reading steady (& possibly correct] .. but am happy ...
159. New Owner Questions : Elan Discussions by LotusElan.net [General]
Hello, all. I've just purchased a lovely S3 SE FHC and drove it 500 miles home from the vendor last Saturday. I have acouple of ...
... problem, get a new cable. If there is no electronic ignition, the Tacho problem may be dirty contacts in the springy loop that is used to conduct ...
160. Powerspark electronic ignition conversion. : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hello all I recently decided to give in condenser on the +2. This was a decision I?ve been putting off for a while now as ...
... Pertronix seemed to be most popular recently but with random possible problems with the original tacho. My friend John had been using an Aldon ignitor in his Elan for ...
161. Any similar tachometer cases/internals? : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi all, I have the early style tachometer on my S3 Elan. The tacho is hopeless as it is erratic as well as reading much ...
... Hi all, I have the early style tachometer on my S3 Elan. The tacho is hopeless as it is erratic as well as reading much too high. ...
162. Magnetronic Lumenition Ignition : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Does one of you have the experience with this ignition system? Is it worth using it in place of the original contact breaker? Do I ...
... it reliable. chicagojeff Thanks for answering. Chicagojeff, what's the problem with the tacho? Can you explain me what you mean with "will screw up the ...
163. Back of Tach : Electrical / Instruments - Page 2 by LotusElan.net [Electrical / Instruments]
Thanks Alan Richard
... Tach Thanks Alan Richard RichardS alan71 wrote: Bill, I agree, internally the tacho needs fixed amplitude pulses but they are regulated a zener diode. If you ...
164. Electronic Ignition : Engine / Exhaust / Cooling by LotusElan.net [Engine / Exhaust / Cooling]
Hi, has anyone tried this Microdynamics Electronic Ignition Module/Distributer? I wonder; will the Tacho on my early Elan +2 still fucnction? Regards Kevin Kober London, ...
... anyone tried this Microdynamics Electronic Ignition Module/Distributer? I wonder; will the Tacho on my early Elan + 2 still fucnction? Regards Kevin Kober London, ...
165. Aldon Ignitor : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi, Can anyone tell me if a Lucas gold sports coil is compatible with the aldon ignitor points replacement system. And.......does the tacho work with ...
... gold sports coil is compatible with the aldon ignitor points replacement system. And....does the tacho work with it. Cheers Mark mark030358 Just Fitted an ALDEN ignition unit into ...
Search took 0.144 seconds