Lotus Elan

LotusElan.net Unified Search

Search results for: diff bearing heat in all categories

171 results found containing all search terms.

9 pages of results.
I need to replace my diff input shaft bearing, can this be done with the diff in situ? Thanks for any advice.
... Diff Input Shaft Bearing Replacement I need to replace ... diff input shaft bearing, can this be done with ... , you may have to heat up the diff casing ...
Terms matched: 3  -  Score: 1261  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=45057
You do not need heat to separate the 2 flanges. Just tap harder on one flange or use a sharp cold chisel and bolster in ...
... has come loose. Later diffs were an improved design ... problem is that the pinion bearings have lost their preload ... undone. You do not need heat to separate the 2 ...
Terms matched: 3  -  Score: 942  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=50661&start=15
Quick stop in today , removed circlip and the stub axle is stuck in there good. Service manual says tap it out ...hmmmmm I carefully ...
... Diff. removal and jackstand placement -Snapped output shaft ... on tossing the circlip and bearing .. as of right ... search for "diff bearing heat": http: ...
Terms matched: 3  -  Score: 817  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=22593&start=30
Hi All, Does anyone have a list of part #'s for bearings and seals for the gearbox and diff? the part #'s I have from ...
... seals for the gearbox and diff? the part # ... gearbox bearings and seals Hi All, Does anyone ... of materials vs oils, heat etc. Thanks Scott ...
Terms matched: 3  -  Score: 790  -  URL: https://lotuselan.net/forums/viewtopic.php?f=16&t=13442
I've been attempting to remove the drive shafts (with anti-flail pins) from a spare diff I've gotten hold of - without success to date. I've ...
... Diff Output Shafts - What Slide Hammer? I've ... date. I've soaked the bearings (over a period ... Wrench' and I've applied heat using a heat gun ...
Terms matched: 3  -  Score: 784  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=27528
6. leaking seal : Archive by LotusElan.net [Mailing List Archive]
Hi, I have just discovered the oil seal on the passenger diff drive shaft is leaking on my +2. Any tips/advise/uk supplier would be most ...
... oil seal on the passenger diff drive shaft is leaking ... case it was the output bearing that had broken up ... car, an application of heat usually helps. Once ...
Terms matched: 3  -  Score: 751  -  URL: https://lotuselan.net/forums/viewtopic.php?f=16&t=9730
7. spyder shafts : Archive by LotusElan.net [Mailing List Archive]
Steve are secured with a standard cable tie. The original hub, outer drive shaft and disk (rotor) assy remains as-is. splined stub were integrated (a ...
... the drive shafts from the diff "( tried that ... ali rear cover around the bearings, still no movement ... still looking for the T shirt) What now, ...
Terms matched: 3  -  Score: 740  -  URL: https://lotuselan.net/forums/viewtopic.php?f=16&t=4129
Apparently this CV driveshaft has been on the car for a long time. In removing it to replace a torn boot, the inner cv came ...
... the bearing circlip in the diff case. Greg Z ... cv came apart, ball bearings everywhere.. I can't ... slide hammer, with some heat on the part that ...
Terms matched: 3  -  Score: 603  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=17518
I have a stuborn diff out put shaft - normally I tap them out per the manuel , gently, ... On this particular dif I ...
... trick for sticky diff outputshaft ?? I have ... heated the area where the bearings were until alloy housing ... hot, hot, hot and then tried a slide ...
Terms matched: 3  -  Score: 591  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=16968
My diff gets sooooo hot that it melts the tie rod rubbers! And the roadsports regs in HSCC do not allow an oil cooler to ...
... Diff Seals My diff gets sooooo hot that it ... surface of the gear, bearing, crank, etc ... smooth, it is actually rough when measured on the ...
Terms matched: 3  -  Score: 528  -  URL: https://lotuselan.net/forums/viewtopic.php?f=12&t=18750
If the shaft was too far out the bigger gap would be on the outside of the caliper. Therefore if it needs shims, the gap ...
... housings, ie hubs and diff casing, is heat ... into it but the original bearings are not sealed they ... and diff casing, is heat, and a lot ...
Terms matched: 3  -  Score: 524  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=46410&start=30
Yes. IMG_4445.jpg On the right, the old shaft with inside bearing in situ, as it came out of the car. On the left, the new ...
... whether I should take the diff out to fit the ... Rear wheel bearing - "Knocking from suspension over ... a total pig. I heated it up quite a ...
Terms matched: 3  -  Score: 497  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=40997&start=75
If the Cv joint has been assembled into the spigot on the diff output shaft with loctite depending on the grade used it may take ...
... into the spigot on the diff output shaft with loctite ... and ruin the seals and bearings. Pulling the diff ... shaft requires removing the circlip in the alloy housing gripping ...
Terms matched: 3  -  Score: 492  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=17518&start=15
Well done Jon and i think i would do the same and leave the output shafts alone. Don't take any risks Alan
... decide later to remove the Diff Output Shafts you can ... it. I expect the bearings have been loctited in ... hand you'll have to apply heat pretty forcefully to destroy ...
Terms matched: 3  -  Score: 451  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=41056&start=60
Well, it's definitely a shot bearing this time - in less than 150 miles! So I've either installed it incorrectly, or there's some other problem. ...
... : Rear suspension bushes+ Diff top mounts+ diff ... Rear Wheel bearing problem, again - Part II ... them? I prefer to heat up a bearing to ...
Terms matched: 3  -  Score: 443  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=13096
Thanks for all the replies. The holes in the outer tube are near the bottom. Someone used set screws that were too long in a ...
... seal kit for the rear diff and hub shafts. ... the outer tube from aluminum bearing assembly and replace with ... to the bearing assembly to heat it up and hope ...
Terms matched: 3  -  Score: 442  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=34204&start=15
Over three decades of elan ownership, you become a little wiser about the various lotus quirks, and develop a better understanding of these great little ...
... is also very useful for diff out put shafts. ... Strut - Axle Shaft & Bearing Removal. Over three ... fitted shaft. Apply some heat to the ally case ...
Terms matched: 3  -  Score: 426  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=24036
Salut Along with Leslie's lovely looking diff, I managed to find a good diff case and late output drive shafts for not much money (always ...
... Removing diff output shaft bearings Salut Along with Leslie's ... looking diff, I managed to find a good diff ... to use a bit of heat on the diff casing ...
Terms matched: 3  -  Score: 413  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=24926
David, The bearings used in the hubs are a deep groove conrad type ball bearing. They are the most widely used type of ball bearing ...
... the bump limit towards the diff, then release the ... Rear hub bearings David, The bearings used in ... have no clearance, the heat they generate under speed ...
Terms matched: 3  -  Score: 395  -  URL: https://lotuselan.net/forums/viewtopic.php?f=16&t=10891
Hi everyone, I have just noticed that my rear input diff oil seal has developed an oil leak ? What a pain. Has anyone replaced ...
... noticed that my rear input diff oil seal has developed ... fretting wear or the pinion bearings are loose or both ... would appear that time, heat and oil had taken ...
Terms matched: 3  -  Score: 391  -  URL: https://lotuselan.net/forums/viewtopic.php?f=37&t=1625
Result Pages: 1 2 3 4 5 6 7 8 9 Next >>


Search took 0.176 seconds