LotusElan.net Unified Search
Search results for: bonnet catch in all categories
548 results found containing all search terms.
Refine your search by category:
- Wiki (10)
- Classifieds (63)
- Mailing List Archive (57)
- General (153)
- Body / Chassis / Frame (167)
- Drive Train / Gearbox / Final Drive (10)
- Electrical / Instruments (29)
- Engine / Exhaust / Cooling (40)
- Racing (5)
- Mods (11)
- Misc. (3)
28 pages of results.
221. What did you do to your Lotus today... : General Lotus Discussions - Page 91 by LotusElan.net [General]
Finally got around to changing the oil in my gearbox f=37 f=37 start=15#p360452 Just as well that I did really as there was very little ...
... dash panel for the trim pieces and bonnet release. - I had previously put ... I think I've finally adjusted the bonnet latches so the passenger one actually holds the ...
222. More on wiring : Mods by LotusElan.net [Mods]
Hi sorry if this has been covered before, but I couldn't find a thread with it in... UK RHD Sprint DHC. so I am doing ...
... to a major positive pole under the hood unfused. This main Brown is fully ... broken, the light circuits should not catch fire, nor your white/red ...
223. 1969 Plus 2S project for sale : Lotus Elans and Plus 2's for Sale by LotusElan.net [Classifieds]
For Sale 1969 Lotus Elan plus 2S Reluctantly it?s time to sell my project Elan Car is in process of being rebuilt but due to ...
... and correct new boot hinges new genuine bonnet stay and complete new genuine bonnet latch ... new badges front and rear new driving/spot lights front lights all new parts ...
224. What did you do to your Lotus today... : General Lotus Discussions - Page 85 by LotusElan.net [General]
A beautiful job Phil, I know how many many hours go into getting the engine bay straight! Do you mind me asking why you changed ...
... Phil, 1. What holds your bonnet down? I don't see the rear ... . 2. How do you keep the temp sender conduit so shiny? 3 ...
225. Trim Board Questions : Archive - Page 2 by LotusElan.net [Mailing List Archive]
Ian, You are obviously not holding your Mole grips correctly. I appear to have mistaken the back of the bulb holder for the back of ...
... fastened to them for lashing the 2 hood sticks (that fit between the side ... and the other two are for the latch bracket. The list doesn't show any ...
226. Fuel cut Inertia Switch. : Electrical / Instruments - Page 2 by LotusElan.net [Electrical / Instruments]
I've just been reading a post on a Mini Forum about some thing similar, a guy had wired up his electric pump through a Oil ...
... it upright on the bulkhead under the bonnet near the starter solenoid and bonnet catch ... I made a simple aluminium mounting bracket for it as the bulkhead is not vertical ...
227. Dashboard replacement : Body / Chassis / Frame by LotusElan.net [Body / Chassis / Frame]
I?ve just about stripped everything out of my old dashboard, currently the bonnet release cable is putting up a fight but it?ll lose in the ...
... of my old dashboard, currently the bonnet release cable is putting up a fight ... jamming locking unit with a simple magnetic catch Attachments Foxie I think Sue does a ...
228. Fuel Flowing out Carb when running : Fuel System / Carbs by LotusElan.net [Classifieds]
The S4 was running a little rough the other day. When I pulled the car into the garage and opened the hood (with engine running) ...
... car into the garage and opened the hood (with engine running) I saw ... , not a lot but enough to catch the lip of the float and keep ...
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... SS:GB:1123 Not for the faint hearted, but here's a +2 that needs rescuing. Should it be completed as a zetec conversion or put ...
... the engine bay and the new looking bonnet catches give a clue, it may ... be a lot better than the photos show, and perhaps has been sitting outside ...
230. The abridged saga of my Europa lunacy : General Lotus Discussions - Page 3 by LotusElan.net [General]
Hi Chuck Love your cars, good to see others who have an interest in the Europa, a very underrated car in my opinion. The Elan ...
... . I actually removed the boot and bonnet locking mechanisms from my car. I ... unless they look at the engine and catch a glimpse of the sides. I ...
MSA Euroclassic 2010 in a 1967 Lotus Elan...................a travelogue...............or?? Excited? you bet, a group of us, 18 in number, the dirty dozen and a half, ...
... the steering and suspension and fastened the bonnet down with a big hammer and cable ... last Little Chef before Hull ready to catch the Zeebrugge ferry. The trouble with ...
232. engine bay : Engine / Exhaust / Cooling by LotusElan.net [Engine / Exhaust / Cooling]
I asked a question on June 05 but foolishly at the end of a reply in the never ending door thread. Foolish I expect because ...
... , Thanks again! Interestingly the two bonnet catches mounted near the top of the ... are also mounted onto small pieces of timber, each slightly shaped so as to ...
233. Bright Zinc Plating : Body / Chassis / Frame by LotusElan.net [Body / Chassis / Frame]
Can anyone recommend a firm to do this work. I have lots of small parts - bonnet catches, door checks etc to plate and need ...
... I have lots of small parts - bonnet catches, door checks etc to plate ... need a reliable and cost effective service. Cheers Jon jono buy a small plating ...
A friend has contacted me to help sell his ill father's Elan. The friend thought the car was an S2, but it appears to me ...
... . S4 dash 2. Power bulge bonnet 3. Stromberg head (with SU's ... pre Super Safety. The inner door latch levers are somewhat teardrop shape and hang ...
I booked in for an MOT test on Monday morning (tomorrow) and on Saturday was clearing out the tools early today. Visions of a dead ...
... on this video: 1) your bonnet is lifting - about 1:30 ... post office before the dumb computer systems catch on to the face that I will ...
236. Elan S4 being awakened after 35 year slumber. : Elan Discussions - Page 5 by LotusElan.net [General]
The biggest problem with removing-inserting engine-gearbox combination is that the workshop manual was written before the gear lever got an anti sizzle connector! So when ...
... bumpers and wheels, and a new hood, will get the old thing looking ... plastic dome and a short stub which catches on body work. As soon as ...
237. Boot lid : Body / Chassis / Frame by LotusElan.net [Body / Chassis / Frame]
Cannot get gaps even on sides,also boot stay is fouling undersides ,are boot lids all made to fit individually?
... that with 30 years of standing without bonnet bootlid or doors, the rear panel ... to engage the early type manual boot catch. I?m hoping that it ...
238. Wiper Woes : Plus 2 Discussions by LotusElan.net [General]
Evening all. Apologies if this topics been done to death but I've not found any specific answers in the forum search. Since owning my car ...
... the bulkhead each side then around the bonnet release triggers. So if ever the ... each side and it released the bonnet latches. IIRC he said he had once ...
239. Engine mounts again : Engine / Exhaust / Cooling - Page 2 by LotusElan.net [Engine / Exhaust / Cooling]
I just looked at Spyders website and they list mountd for Plus 2 as a pair and, separately, carb side for the Elan. So it ...
... ! The Strombergs stick UP into the bonnet so don't need to be pushed up ... yet to have the holes that the latches catch on cut so I can't say ...
240. Purists Look Away : Elan Discussions by LotusElan.net [General]
Now that Steve has set me right on the photo front (thanks again) I am going to download a few photos of my non standard ...
... routing was important to avoid hitting the bonnet when it opens. I squeezed it ... box with brackets welded on for oil catch bottle, oil filter housing and filter ...
Search took 0.150 seconds